As I mentioned in my previous post, I bought a new 3D Printer and wanted to move it downstairs to keep the noise to a minimum. They are not loud, but since some prints take 12 hours, or more to print, I thought I would move the computer room downstairs and build a large desk.

The desk is made up of 2 x 3/4″ pieces of Oak Plywood wrapped in solid Oak Wood for a total of 1 1/2″ thick. It is almost 11′ long and made into a single piece. There are no sides, only braces on either side and the middle to support the top. I then added a 3′ piece to make a “L” shape to hold our printers.

To support the middle of the desk better, and to provide better storage, I made a cabinet of 4 x 6″ high drawers (14″ wide x 20″ deep). The cabinet is Oak plywood wrapped in solid oak. The drawers are all solid oak. I was going to make dovetail drawers, but ended up doing box joints again like I did on the toy boxes for my nephews. I planned on putting drawer fronts on, but I like the look of the box joints. So I will leave it for now.

Computer Desk

Advertisements